P0106: Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance
The manifold pressure reading does not fit the engine speed, throttle position and other sensor values.
Normal risk
Usually drivable, but the engine may run unevenly or use more fuel. Have it checked soon.
Short answer · Can I keep driving with P0106?
Usually yes. The engine may hesitate, idle unevenly or use more fuel. Check the sensor hose and look for intake leaks soon.
What does P0106 mean?
Code P0106 means the MAP sensor signal is electrically valid but implausible. The control unit compares it with barometric pressure when the engine is off and with throttle position and speed when running.
Leaking hoses and intake leaks are common causes.
What the car does when the code is set
The check engine light comes on. The engine uses a substitute value, so it may hesitate, idle unevenly, use more fuel or produce black smoke. On turbo engines, power may be limited.
How the system works
The manifold absolute pressure (MAP) sensor measures the pressure, or vacuum, in the intake manifold. Low pressure means low engine load; high pressure means high load or boost. The engine control unit uses it to calculate load and fuel quantity, and on turbo engines to control boost. The sensor sends a voltage that rises with pressure; with the engine off, the reading should match outside air pressure.
Common symptoms
Possible causes
Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.
- Split or disconnected vacuum hoseThe sensor reads manifold pressure through a small hose or port; a leak or loose hose gives a wrong reading.
- Intake leakAir leaking past a gasket or hose changes manifold pressure and the fuel calculation.
- Dirty or oily sensorOil vapour from the crankcase ventilation can coat the sensing element.
- Wiring or connector faultA broken wire, corrosion or a poor reference voltage changes the signal.
- Failed sensorThe sensor itself can drift or fail with age.
How it is diagnosed
- Check the hose and connectorMake sure the sensor is firmly connected and any vacuum hose to it is intact and not blocked.
- Compare the reading with the engine offWith the ignition on and the engine stopped, manifold pressure should be close to the barometric pressure for your altitude.
- Look for intake leaksA smoke test finds leaks in the intake manifold, hoses and gaskets.
- Measure supply, ground and signalA workshop checks the reference voltage and signal at the connector against the service data.Do not pierce wire insulation to take readings; it lets moisture in and causes new faults.
Questions about P0106
Can a vacuum leak set P0106?
Yes. A leak raises manifold pressure at idle, so the reading no longer fits what the engine expects.
Is the MAP sensor the same as the MAF sensor?
No. The MAP sensor measures pressure in the intake manifold, the MAF sensor measures the air flow entering the engine. Some engines use both.