P0332: Knock Sensor 2 Circuit Low (Bank 2)
The signal from knock sensor 2 on bank 2 is below its normal range.
Normal risk
Usually drivable, but power and economy may suffer. Avoid heavy loads until fixed.
Short answer · Can I keep driving with P0332?
Yes, gently. The engine retards timing and loses some power. Have the sensor and wiring checked soon.
What does P0332 mean?
Code P0332 means the bank 2 knock sensor signal is weaker than expected. A loose sensor, damaged wiring, corrosion or a failed sensor are common causes.
What the car does when the code is set
The check engine light comes on. The engine retards the ignition timing as a safety measure, so it may feel slightly weaker and use a little more fuel. Otherwise the car drives normally.
How the system works
Knocking happens when part of the mixture ignites on its own instead of being burnt by the flame front. It sounds like metallic pinging and can damage pistons if it continues. The knock sensor is a small piezo element bolted to the engine block that turns vibration at the typical knock frequency into a voltage. The engine control unit listens to this signal at each combustion and retards the ignition of a cylinder that knocks. If the sensor signal is missing or out of range, it cannot detect knock and so retards timing as a precaution.
Common symptoms
Possible causes
Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.
- Faulty knock sensorThe sensor's piezo element fails.
- Wiring or connector problemThe sensor is often under the intake manifold where wiring gets hot and brittle.
- Incorrect tightening torqueA sensor that is too loose or too tight gives a wrong signal.
- Control unit input faultRare.
How it is diagnosed
- Check the wiring and connectorLook for damage, corrosion and oil in the connector.
- Measure the sensorCheck the sensor resistance or signal against the service data.
- Check its mountingMake sure the sensor sits clean on the block and is tightened to the specified torque.
- Clear and test-driveClear the code and drive under load to confirm the repair.
Questions about P0332
Should both knock sensors be replaced?
Not necessarily, but on engines where both are under the intake manifold, many workshops replace both at once to save labour later.
Can I drive with a knock sensor code?
Usually yes. The engine retards its ignition timing for safety, so it may have less power and use more fuel. Avoid hard acceleration with heavy loads.
Is the knocking noise I hear related?
Possibly. If the sensor does not work, the engine cannot respond to real knocking. Use the fuel grade specified in your manual.
Why did the code appear after an intake manifold repair?
The knock sensor is often under the manifold. Its connector or wiring may have been damaged or not reconnected.