Skip to content
EN · km
Units
My Garage
Generic SAE code Network communication

U0235: Lost Communication With Cruise Control Front Distance Range Sensor

Other control units no longer receive messages from the Front Distance Sensor.

High risk

Have it checked soon. Adaptive cruise control and collision warning may not work.

Short answer · Can I keep driving with U0235?

Usually yes, with care. Adaptive cruise control and collision warning may not work. Have the network and the module checked soon.

On this page

What does U0235 mean?

Code U0235 means a control unit expected regular messages from the Cruise Control Front Distance Range Sensor on the vehicle network and they stopped arriving. A power or ground fault at that module, a damaged network wire or corroded connector, low battery voltage or a failed module are typical causes.

What the car does when the code is set

Functions that depend on the affected module are switched off. ABS, stability control, cruise control or power steering assistance may be unavailable, with matching warning lights.

How the system works

The ABS control module and power steering module share wheel speed, steering angle and other data over the network. Other modules rely on this data and store a lost communication code when it stops arriving.

UNetwork
0Generic code (SAE)
2Network communication
35Specific fault

Common symptoms

Possible causes

Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.

  1. Power or ground fault at the moduleA blown fuse or poor ground switches the module off.
  2. Connector corrosionModules near the wheels or under the car are exposed to water and salt.
  3. Damaged network wiringChafed or corroded CAN wires.
  4. Low battery voltageVoltage dips can cause temporary communication loss.
  5. Failed moduleLess common than wiring faults.

How it is diagnosed

  1. Check which warning lights are onABS, stability control or steering warnings show which system is affected.
  2. Check fuses and battery voltageStart with the simplest causes.
  3. Inspect the module connectorLook for corrosion and loose pins.Disconnect the battery only as described in the manual; some modules need a relearn afterwards.
  4. Scan all modulesA workshop checks whether the module responds and tests the network wiring.

Questions about U0235

Can a weak battery cause U0235?

Yes. Low voltage during starting can make modules drop off the network for a moment and store this code. Check the battery before replacing any module.

Do the brakes still work?

Normal braking usually remains, but ABS and stability control may be off. Drive carefully and have it checked.

Terms on this page