P0141: O2 Sensor Heater Circuit (Bank 1 Sensor 2)
The heater circuit of the rear oxygen sensor on bank 1 has a fault.
Normal risk
Safe to drive. It mainly affects emission monitoring. Fix it soon.
Short answer · Can I keep driving with P0141?
Yes. The rear sensor mainly monitors the catalytic converter, so driving is not affected much. Have it fixed before an inspection, as the emission monitor cannot complete.
What does P0141 mean?
Sensor 2 is the oxygen sensor after the catalytic converter on bank 1. Code P0141 means its heater circuit has a fault, usually a failed heater element, wiring damage or a blown fuse.
The rear sensor mainly checks the catalytic converter. Without its heater, the catalyst test cannot run properly.
What the car does when the code is set
The check engine light comes on. The car drives normally. After a cold start the engine relies on default values for longer before it uses the sensor, so emissions are higher for the first minutes. Some emission readiness tests will not complete.
How the system works
Oxygen sensors only produce a useful signal when their tip is several hundred degrees hot. Exhaust heat alone takes minutes to get there, so each sensor has an electric heater. The engine control unit switches the heater on and off and monitors its current or resistance. If the current is too low (open circuit), too high (short) or the sensor does not warm up in time, it stores a heater code for that sensor. While the heater does not work, the engine relies on default values for longer after a cold start.
Common symptoms
Possible causes
Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.
- Failed heater elementThe heater inside the sensor burns out.
- Blown fuseMany cars have a separate fuse for the sensor heaters.
- Wiring or connector damageThe wiring runs near the hot exhaust and can melt or chafe.
- Control unit driver faultRare: the control unit no longer switches the heater.
How it is diagnosed
- Check the fuseFind the oxygen sensor heater fuse in the owner's manual or fuse box lid.
- Inspect the wiringFollow the wiring from the sensor and look for heat damage or chafing.
- Measure heater resistanceUnplug the sensor and measure the resistance of the heater pins. Compare with the service data; an open circuit means the sensor needs replacing.
- Check the supplyWith the ignition on, check the heater supply voltage at the connector.The exhaust and sensors are very hot after driving.
Questions about P0141
Why does the sensor need a heater?
Oxygen sensors work only when hot. The heater brings them to temperature quickly after a cold start, so the engine can use them sooner.
Can I drive long distances with a heater code?
Yes, it does not harm the engine. Emissions after cold starts are higher and some emission monitors will not complete.