P0162: O2 Sensor Circuit (Bank 2 Sensor 3)
The engine control unit has detected a fault in the circuit of oxygen sensor bank 2 sensor 3.
Normal risk
Usually safe to drive. Have it checked soon.
Short answer · Can I keep driving with P0162?
Yes, usually. This sensor sits far down the exhaust and does not control the mixture, so the car drives normally. Have it checked soon so the emissions system can be monitored again.
What does P0162 mean?
Code P0162 means the engine control unit found a general fault in the circuit of this sensor, for example no usable signal. A damaged wire, a corroded connector or a failed sensor are typical causes. Sensor 3 is a third oxygen sensor that only some cars have, usually after a second catalytic converter; it does not control the mixture.
What the car does when the code is set
The check engine light comes on. For a front sensor, the engine may stop using the sensor and run on a fixed mixture, which can raise fuel use and emissions. A rear sensor fault mostly affects the catalyst test.
How the system works
Oxygen sensors measure the oxygen left in the exhaust. The front sensor, before the catalytic converter, tells the engine control unit whether the mixture is rich or lean so it can correct the fuel. The rear sensor, after the converter, checks how well the converter works. The control unit watches the sensor voltage and current; if the signal stays too low, too high or does not change, it stores a circuit code.
Common symptoms
Possible causes
Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.
- Failed oxygen sensorSensors age and can stop producing a proper signal.
- Wiring or connector damageSensor wires run near the hot exhaust and can melt, chafe or corrode.
- Exhaust leak near the sensorOutside air entering the exhaust makes the sensor read lean.
- ContaminationOil, coolant or silicone residues can poison the sensor element.
- Real mixture problemA genuinely rich or lean engine can push the signal to its limits.
How it is diagnosed
- Read live sensor dataWith the engine warm, a working front sensor switches rapidly or follows mixture changes; a stuck or flat signal points to the sensor or wiring.
- Inspect the wiring and connectorFollow the sensor wire for melted insulation, chafing or corrosion at the plug.
- Check for exhaust leaksLook and listen for leaks at the manifold and joints near the sensor.
- Fix fuel trim problems firstIf lean or rich codes are also stored, they may be the cause rather than the sensor.Let the exhaust cool before working near the sensor.
Questions about P0162
Where is sensor 3?
It is the third oxygen sensor along the exhaust, counted from the engine. Bank 2 is the side of the engine without cylinder 1; the service data shows its exact position.
Does a new oxygen sensor always fix the code?
Not always. Wiring damage, exhaust leaks and real mixture faults cause the same codes, so check them before replacing the sensor.