P0405: Exhaust Gas Recirculation Sensor "A" Circuit Low
The EGR position sensor signal is below its normal range.
Normal risk
Usually drivable, but emissions rise and power may be limited. Have it checked soon.
Short answer · Can I keep driving with P0405?
Usually yes. The control unit may close the EGR valve and limit its use. Have the sensor and wiring checked soon.
What does P0405 mean?
Code P0405 means the signal from the EGR valve position sensor is lower than a working sensor gives. An open circuit, a missing 5 V reference, a short to ground or a failed sensor are typical causes.
What the car does when the code is set
The check engine light comes on. Most cars drive normally, though some petrol engines knock under load and some diesels feel less smooth. Nitrogen oxide emissions are higher.
How the system works
Exhaust gas recirculation feeds a controlled amount of exhaust gas back into the intake. The inert exhaust gas lowers the peak combustion temperature, which reduces nitrogen oxide (NOx) emissions and, on petrol engines, helps prevent knocking. An electrically or vacuum-operated valve controls the flow, and many engines have a cooler to lower the gas temperature. The engine control unit checks the flow by watching the intake pressure, air-flow reading or a position sensor while it opens the valve. If the change is smaller than expected, it stores an insufficient-flow code.
Common symptoms
Possible causes
Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.
- Faulty EGR position sensorThe position sensor on the EGR valve wears or fails, and its signal drops out of range.
- Carbon in the EGR valve or passagesThe most common cause, especially on diesels and direct-injection petrol engines.
- EGR valve stuckThe valve does not open as far as commanded.
- Faulty EGR position or pressure sensorThe control unit cannot measure the flow correctly.
- Vacuum or wiring faultOn vacuum-operated valves, a leaking hose or a faulty solenoid.
How it is diagnosed
- Command the valve with a scan toolMany scan tools can open the EGR valve and show its position. Compare commanded and actual position.
- Inspect for carbonRemove the valve and look at it and the passages. Heavy carbon must be cleaned or the parts replaced.
- Check the sensorsCheck the readings of the EGR position sensor and the intake pressure sensor.
- Clear and test-driveAfter the repair, clear the code and drive at varying loads to let the monitor run.
Questions about P0405
Is the EGR sensor part of the valve?
On most engines yes, so the valve is replaced as a unit.
Can the EGR valve simply be blocked off?
Removing or blocking the EGR system breaks emission rules in most countries and can fail an inspection. It is not a legal repair.
Does driving style affect EGR clogging?
Yes. Many short trips and long idling increase carbon build-up. Regular longer drives at higher load help.