Skip to content
EN · km
Units
My Garage
Generic OBD-II code Emission controls

P0449: Evaporative Emission System Vent Valve/Solenoid Circuit

The engine control unit has detected an electrical fault in the evaporative system vent valve circuit.

Normal risk

Safe to drive. Have it checked at the next opportunity.

Short answer · Can I keep driving with P0449?

Yes. If the vent stays closed, refuelling may become difficult. Have the vent valve and wiring checked.

On this page

What does P0449 mean?

Code P0449 points to the vent valve, which opens the charcoal canister to fresh air and closes it for leak tests. It usually sits near the fuel tank, where road dirt and water reach the connector.

What the car does when the code is set

The check engine light comes on. Driving is not affected. Some fuel vapour escapes into the air, and in many countries the car fails the emissions part of an inspection while the code is active.

How the system works

Petrol gives off vapour, especially when warm. Instead of letting it escape, the evaporative emission system stores it in a charcoal canister. When the engine runs under suitable conditions, the purge valve opens and the engine draws the vapour in and burns it. To make sure the system is sealed, the engine control unit runs a leak test, usually after the car has been parked: it closes the vent valve and either creates a vacuum or applies pressure, then watches whether it holds. The size of the leak it detects decides which code is stored.

PPowertrain
0Generic code (SAE)
4Emission controls
49Specific fault

Common symptoms

Possible causes

Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.

  1. Open or shorted vent valve circuitA failed solenoid coil, a corroded connector or damaged wiring near the tank.
  2. Loose, damaged or wrong fuel capThe most common and cheapest cause.
  3. Cracked hose or loose connectionHoses between the tank, canister and engine age and crack.
  4. Faulty purge valveA valve that does not seal lets vapour escape.
  5. Faulty vent valveThe vent valve on the canister does not close during the test.
  6. Leaking filler neck or canisterRust on the filler neck or a cracked canister.

How it is diagnosed

  1. Check the fuel capCheck the seal, close the cap until it clicks, and clear the code. The test runs again over several drive cycles.
  2. Inspect visible hosesLook at the hoses near the canister and engine for cracks and loose connections.
  3. Smoke-test the systemA workshop fills the system with smoke at low pressure; the smoke shows where it escapes.
  4. Test the valvesPurge and vent valves are tested with a scan tool or by applying voltage, as described in the service data.

Questions about P0449

Where is the vent valve?

On most cars it is near the charcoal canister, close to the fuel tank under the rear of the car.

Is an evaporative leak dangerous?

Small leaks are not a direct danger, but they release fuel vapour. A strong fuel smell, especially inside the car, should be checked straight away.

Will the car fail an inspection?

In many countries a lit check engine light fails the emissions test, even for a small evaporative leak.

Terms on this page