P2453: Diesel Particulate Filter "A" Pressure Sensor Circuit Range/Performance
The particulate filter pressure sensor signal is implausible.
Normal risk
Usually drivable, but the filter may not regenerate. Have it checked soon to avoid a blocked filter.
Short answer · Can I keep driving with P2453?
Usually yes, but power may be limited and the filter can fill up because the engine cannot judge the soot load. Have it checked soon.
What does P2453 mean?
Code P2453 means the pressure reading is within its electrical range but does not fit the engine load, for example it does not rise with exhaust flow. Split, blocked or swapped sensor hoses are a common cause.
What the car does when the code is set
The particulate filter or check engine light comes on. The engine control unit can no longer measure the soot load, so it may suspend regeneration or regenerate at fixed intervals. Some cars limit power.
How the system works
The differential pressure sensor is connected to the exhaust before and after the particulate filter by two small hoses or pipes. It reports how much the filter resists the exhaust flow, which tells the engine control unit how much soot is inside and when to start a regeneration. If the sensor signal is out of its electrical range, the control unit cannot judge the soot load and usually turns on a warning and limits regenerations.
Common symptoms
Possible causes
Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.
- Faulty differential pressure sensorThe sensor fails.
- Wiring or connector faultDamage near the hot exhaust.
- Blocked or split sensor hosesSoot or condensation blocks the hoses.
How it is diagnosed
- Check the hosesLook for splits, blockages and swapped connections.
- Check the reading with the engine offIt should be close to zero.
- Check supply, ground and signalAs described in the service data.
- Replace and testAfter repair, clear the code and check the reading at idle and under load.
Questions about P2453
Can the sensor hoses cause P2453?
Yes. The two thin hoses can split, block with soot or be fitted the wrong way round. They are checked before the sensor.
Will the filter clog without the sensor?
Without the sensor, regeneration timing is guessed. Over time the filter can clog.
Are the hoses easy to check?
Usually yes. They run from the exhaust to the sensor and can crack or come off.