Gear Shift Cable (Linkage)
Gear shift cables or rods connect the gear lever to the gearbox so the driver's movement selects the gears.
What is Gear Shift Cable (Linkage)?
Most front-wheel-drive cars use two cables, one for selecting and one for shifting. Bushings at the ends wear over time. Automatic selectors also use a cable or electronic link. After replacing cables, the linkage usually needs adjusting with a locking pin so the lever sits in the correct neutral position.
How it works
Moving the lever pulls or pushes the cables, which move the selector shaft on the gearbox.
Why it matters for your car
Worn bushings make the lever sloppy and can make gears hard to find. A broken cable can leave the car stuck in one gear.
Other terms
- Bluetooth Hands-free System
- CV Joint (Constant Velocity Joint)
- Door Hinge
- Driving In Fog
- ESP / Stability Control Warning Light
- Knock Sensor
- MAP Sensor (Manifold Absolute Pressure)
- Night Vision Assist
- Oil Cooler
- Over-the-air Update (OTA)
- Parallel Parking
- Power Band
- Pressure Washer
- Respray (Refinish)
- Right-Hand Drive (RHD)
- Side Impact Beam (Door Beam)
- Smart Charging (Alternator Control)
- Tyre Pressure Gauge
- Unit Injector (Pump Injector)
- Water-Methanol Injection