P0175: System Too Rich (Bank 2)
The engine on bank 2 is running with too much fuel, and the fuel correction has reached its limit.
Normal risk
Usually drivable, but the catalytic converter can be damaged over time. Have it checked soon.
Short answer · Can I keep driving with P0175?
Usually yes, for short trips. A rich engine uses more fuel and can damage the catalytic converter, so have it checked soon.
What does P0175 mean?
Code P0175 means the control unit is removing as much fuel as it can from bank 2, and the mixture is still rich. Bank 2 is the side without cylinder 1 on V and boxer engines.
Leaking injectors, high fuel pressure and air-flow measurement errors are common causes.
What the car does when the code is set
The check engine light comes on. The engine keeps running, but the exhaust may smell of fuel and fuel consumption usually rises. Spark plugs can foul over time, which leads to misfires, and the extra fuel heats the catalytic converter.
How the system works
The engine control unit calculates the fuel quantity from the measured air and then corrects it with the front oxygen sensor. When the burnt mixture is rich, it removes fuel; this negative correction is called fuel trim. The correction has a limit. If the control unit removes the maximum amount of fuel and the oxygen sensor still reports a rich mixture, it stores a rich code. That means fuel is arriving from somewhere the system does not control, or the air is being measured too low.
Common symptoms
Possible causes
Listed without ranking. The cause on your car depends on make, engine and mileage — see the maker notes below.
- Leaking injectorAn injector that drips or sprays too much adds extra fuel.
- Fuel pressure too highA faulty pressure regulator or a blocked return line raises fuel pressure.
- Faulty air-flow sensorThe sensor over-reports the air, so the engine adds too much fuel.
- Purge valve stuck openFuel vapour from the canister enters the intake all the time.
- Faulty coolant temperature sensorA sensor that reads cold makes the engine run a cold-start mixture.
How it is diagnosed
- Look at fuel trims and sensorsStrongly negative fuel trims confirm the engine is removing fuel. Check coolant temperature and air-flow readings for plausibility.
- Test the purge valvePinch or disconnect the purge line with the engine idling (where the service data allows): if trims return to normal, the valve leaks.
- Check fuel pressure and injectorsA pressure test with a hold test shows leaking injectors or a faulty regulator.
- Inspect the oilFuel smell in the engine oil points to leaking injectors.
Questions about P0175
Why only bank 2?
A fault affecting only one side, such as a leaking injector or a sensor on that bank, sets a code for that bank. If both banks are rich, look for a shared cause.
Does a rich mixture damage anything?
Over time the extra fuel can foul spark plugs and overheat the catalytic converter, so it should be fixed soon.
Why does my exhaust smell of fuel?
With a rich mixture not all fuel is burnt. The smell usually disappears once the cause is fixed.