Compression Test
A compression test measures the pressure each cylinder builds while the engine is cranked, showing whether it seals properly.
What is Compression Test?
A gauge is screwed into each spark plug or glow plug hole in turn. The results are compared across cylinders and with the specification. A leak-down test can then show where pressure escapes. A wet test adds a little oil to a low cylinder: if the reading rises, the rings are leaking; if not, valves or the gasket are likely.
How it works
Cranking the engine makes the piston compress the trapped air. Leaking rings, valves or a head gasket reduce the reading.
Why it matters for your car
One low cylinder points to a local fault, such as a burnt valve; two adjacent low cylinders can mean a head gasket failure. For accurate results, test with a fully charged battery, a warm engine and the throttle open, as the procedure specifies.
Other terms
- Borescope (Inspection Camera)
- Clutch Judder
- Dual-Zone Climate Control
- Headlight Aiming
- Ignition Timing
- Intelligent Battery Sensor (IBS)
- Paintless Dent Repair (PDR)
- Part-Worn Tyre
- Periodic Technical Inspection (MOT, TÜV)
- Radiator Stop Leak
- Remanufactured Parts
- Returnless Fuel System
- Reversing Light Switch
- Stud Extractor (Screw Extractor)
- Total Cost Of Ownership (TCO)
- Trailer Stability Control (Trailer Sway Control)
- Type 1 Connector (SAE J1772)
- Tyre Repair Kit (Sealant Kit)
- Vacuum Advance
- Windscreen Demisting (Defrost)